What is the inlet size of the PGP-ADJ?

The PGP-ADJ has a 3/4-inch inlet

What is the pop-up height of the PGP-ADJ?

The pop-up height of the PGP-ADJ is 4 inches

Can the PGP-ADJ replace any brand of rotor?

Yes, it can replace any brand of rotor with a 3/4-inch inlet

Does it come with the nozzle rack?

This is an official Hunter PGP-ADJ and comes with a pre-installed nozzle and rotor adjustment too.

Does this screw into a one inch thread?

This is 3/4" Female Pipe Thread. You would need an adapter for 1".

How do the numbers on the nozzle inserts correspond to a approx. distance?

The numbers are based on a flow rate. Based on pressure at the head and nozzle will determine distance. You can get a ref chart on the mnf web.

Does it come with the 3/4 to 1 nipple reducer?

No, there is not a reducer or supplemental adaptor included. The receiving part of the Rotor is a 3/4 inch female receptor. I purchased a 3/4 to 1/2 inch adaptor to attach them to ground stakes for an above ground system.

Iv got a leaking sprinkler, should i install check valves on a new replacement?

I had the same problem. I finally took each sprinkler head, took apart and cleaned each one. I also made a test jig to make sure the head did not leak before I installed them back in. I found small pieces of sand in the head that caused the leak. I was able to re-use the all the heads except for one that leaked water thus reducing the water pressure and kept the other heads from popping all the way up.

The tiny hole an inch below nozzle is leaking water around the head. So, is head-to-head coverage needed?

Yes, head to head coverage is correct. I think the small hole is for depressurizing the head when water is turned off.

I am trying to order the improved versions it says it can not be deliverd ? but the old one it ok ?from the same seller,lmk

That will depend on your water pressure, do you know your water pressure? also the nozzle you install in the Hunter head. When you get your water heads they should come with different spray nozzles and directions. The direction will help you a lot to explain the GPM.

Is the spring included?

Yes, it comes as 1 complete unit. If your replacing one that you may have ran over with your lawnmower (wink wink) then all you have to do is spin the old one out and spin the new one in.

Does this come with the adjustment tool?

In general, it appears that Hunter should provide the adjustment tool if you buy a 5-pack of irrigation heads .Otherwise you can purchase one for a few dollars. Also you can adjust the length of the spray with just a 3/32" Allan wrench.

Do the screens clog up quickly? My water come from a spring and has some particulates.

I have never had one clogged and it will operate just fine without the screen.

Explore

Shop By Category

Added to Cart

Your shopping cart is emptyLets Change that !Continue Shopping

https://m.media-amazon.com/images/I/41AOTZh1x-L._AC_US100_.jpg

https://m.media-amazon.com/images/I/41MxZWztZkL._AC_US100_.jpg

https://m.media-amazon.com/images/I/51YEjotswTL._AC_US100_.jpg

https://m.media-amazon.com/images/I/41xwR6PvFmL._AC_US100_.jpg

Hunter Industries

Hunter PGP-ADJ ¾" Rotor, 2-Pack

Name: Hunter PGP-ADJ ¾" Rotor, 2-Pack
Uploaded: 2025-01-13T20:48:44.593Z
Description: Hunter PGP-ADJ ¾" Rotor, 2-Pack

Item #:73195800

4.6 rating

Write a review

PKR 9626PKR 11004 You Save : 13%
Price Detail
Price
PKR 9626
Excluding Shipping & Custom charges
( Shipping and custom charges will be calculated on checkout )
* All items will be imported from US Store

Order now and get it around Tuesday, January 28

Size :1-Pack

1-Pack

2-Pack

Style :Industries Hunter

Industries Hunter

Availability : In Stock

Imported from USA store

Quantity :

Ships from Ubuy, Sold By : UBNA Distribution LLC

Note: Step Down Voltage Transformer required for using electronics products of US store (110-120.). Recommended power converters Buy Now.

Our Top Logistics Partners

The PGP is the world’s No. 1 selling rotary sprinkler delivering unparalleled reliability, durability, and versatility for healthy landscapes.

Product Details

As Hunter’s original rotor, the PGP delivers unsurpassed reliability, durability, and versatility, keeping it the professional’s choice year after year
The 3 GPM nozzle features an adjustable 40° to 360° arc for optimal coverage in a range of applications
The PGP-ADJ rotary sprinkler has a pop-up height of 4 inches and a ¾-inch inlet; it can replace any brand of rotor with a ¾-inch inlet
Unrivaled water efficiency and uniform distribution keep landscapes healthy and beautiful in any environment
Applies water evenly to prevent brown spots from developing near the sprinkler head Fast-forward feature provides quick verification of arc stopping points
PGP-ADJ Dimensions: Retracted Body Height is 7 ¾" (19 cm), Exposed Diameter 1 ¾" (4.5 cm) , Pop-up out of ground when watering is 4" (10 cm)
2 Pack

Brand	Hunter Industries
Color	Black
Material	Plastic
Style	Industries Hunter
Item dimensions L x W x H	2.75 x 5.75 x 7.38 inches (7.0 x 14.6 x 18.7 cm)
Date First Available	2021-3-7 13:8:31

Features & Benefits

Adjustable 3 GPM nozzle arc for even coverage
Can replace any brand of rotor for a 3/4 inch inlet
Unrivaled water efficiency and uniform distribution
Fast forward feature for quick verification
Retracted body height is 7 3/4 inches with a 4 inch pop-up height

Product Description

Hunter PGP-ADJ ¾" Rotor, 2-Pack

Overview

Have any Query?Chat with us

Customer Questions & Answers

Question : What is the inlet size of the PGP-ADJ?
Answer : The PGP-ADJ has a 3/4-inch inlet
Question : What is the pop-up height of the PGP-ADJ?
Answer : The pop-up height of the PGP-ADJ is 4 inches
Question : Can the PGP-ADJ replace any brand of rotor?
Answer : Yes, it can replace any brand of rotor with a 3/4-inch inlet
Question : Does it come with the nozzle rack?
Answer : This is an official Hunter PGP-ADJ and comes with a pre-installed nozzle and rotor adjustment too.
Question : Does this screw into a one inch thread?
Answer : This is 3/4" Female Pipe Thread. You would need an adapter for 1".
Question : How do the numbers on the nozzle inserts correspond to a approx. distance?
Answer : The numbers are based on a flow rate. Based on pressure at the head and nozzle will determine distance. You can get a ref chart on the mnf web.
Question : Does it come with the 3/4 to 1 nipple reducer?
Answer : No, there is not a reducer or supplemental adaptor included. The receiving part of the Rotor is a 3/4 inch female receptor. I purchased a 3/4 to 1/2 inch adaptor to attach them to ground stakes for an above ground system.
Question : Iv got a leaking sprinkler, should i install check valves on a new replacement?
Answer : I had the same problem. I finally took each sprinkler head, took apart and cleaned each one. I also made a test jig to make sure the head did not leak before I installed them back in. I found small pieces of sand in the head that caused the leak. I was able to re-use the all the heads except for one that leaked water thus reducing the water pressure and kept the other heads from popping all the way up.
Question : The tiny hole an inch below nozzle is leaking water around the head. So, is head-to-head coverage needed?
Answer : Yes, head to head coverage is correct. I think the small hole is for depressurizing the head when water is turned off.
Question : I am trying to order the improved versions it says it can not be deliverd ? but the old one it ok ?from the same seller,lmk
Answer : That will depend on your water pressure, do you know your water pressure? also the nozzle you install in the Hunter head. When you get your water heads they should come with different spray nozzles and directions. The direction will help you a lot to explain the GPM.
Question : Is the spring included?
Answer : Yes, it comes as 1 complete unit. If your replacing one that you may have ran over with your lawnmower (wink wink) then all you have to do is spin the old one out and spin the new one in.
Question : Does this come with the adjustment tool?
Answer : In general, it appears that Hunter should provide the adjustment tool if you buy a 5-pack of irrigation heads .Otherwise you can purchase one for a few dollars. Also you can adjust the length of the spray with just a 3/32" Allan wrench.
Question : Do the screens clog up quickly? My water come from a spring and has some particulates.
Answer : I have never had one clogged and it will operate just fine without the screen.

Customer Ratings

4.6 out of 5

3065 customers ratings

5 star
79%
4 star
11%
3 star
7%
2 star
2%
1 star
1%

Review this product

Share your thoughts with other customers

Hunter Industries Editorial Review

The Hunter PGP-ADJ 3/4" Rotor Sprinkler offers precision watering capabilities with its adjustable arc and radius settings. Its automatic operation smoothly transitions through its arc, distributing water evenly and efficiently. The sprinkler head's customizable features account for irregularly shaped sections or specific plant beds along with the ability to switch out nozzles without tools, to adapt the water flow to different plant types and soil conditions. The Hunter PGP-ADJ doesn't compromise on aesthetics either, with its sleek low-profile design. The sprinkler head is easy to install, thanks to the clear instructions accompanying the product and showcases compatibility with existing systems. While the initial cost might seem higher, the longevity and performance of the sprinkler head justify the investment.

Pros

Precise watering capabilities
Automatic operation
Versatility in nozzle compatibility
Aesthetically pleasing design
Easy installation

Cons

Missing tools that are supposed to be included in the package
Some products showed clear signs of previous use
No reducer or supplemental adaptor included in the package

Important Information

Limitations : For products shipped internationally, please note that any manufacturer warranty may not be valid; manufacturer service options may not be available; product manuals, instructions, and safety warnings may not be in destination country languages; the products (and accompanying materials) may not be designed in accordance with destination country standards, specifications, and labeling requirements; and the products may not conform to destination country voltage and other electrical standards (requiring use of an adapter or converter if appropriate). The recipient is responsible for assuring that the product can be lawfully imported to the destination country. When ordering from Ubuy or its affiliates, the recipient is the importer of record and must comply with all laws and regulations of the destination country.
Not all the products listed on Ubuy are for sale, as Ubuy is a global search engine. Products are subject to export/trade regulations.

Hunter PGP-ADJ ¾" Rotor, 2-Pack

View Cart & Checkout