Anyone use this for media blasting?

I dont know about the media, but i have used it to blast telemarketers.

Has anyone run this on a 2000W inverter generator?

Kevin has a point. Yes it will work but the tank will be under load for some time. If you get one of those 2000 watt inverters just make sure it has a fan. Personally I would get a 3000 watt to be on the safe side even though this suckered sucks 15amps quite a lot for just 5.1 scfm

Where do you plug it up

You plug the cord into a 120V outlet and then on the front of this compressor, there are two 1/4" industrial fittings for your hoses.

Why does my compressor lose air after it fills up

If you’re using the air (i.e. nail gun etc) your compressor should decrease in air as it’s being used. IF you have “leak” somewhere within tank system you should be able to hear it, as it’s filling; although it likely wouldn’t fill up due to leak ( probably just keep running). Air usage or leak?? Only you know.

Has anybody filled the tires of a ford f350 or other super duty trucks or 80 psi rv tires yet?

This is a good little compressor for the money. My F350 tires have been low a couple of times and this has filled with no problem. My only reservation is it is loud and has a small capacity tank but it builds pressure quickly up to 200 PSI.

It’s not as loud as a push lawn mower - which is around 80 plus decibels. It’s not as quiet as a newer dishwasher - which is around 50 decibels. Guessing - I would say it’s 55-65 decibels. The sound may seem louder the closer you are to it. If your right next to it or bent over in front of it, it’ll likely seem loud, but if your several feet from unit, it’s not that bad. Also sound will obviously seem much elevated if you’re using compressor inside as opposed to unit being used outside. So I assume decibels will and can vary on where and how you are using the compressor.

Will this compressor build to 200psi continuously or is it rated to 200psi and only builds to 175 or 180 as in other brand compressors?

It will try to hold to 200psi and will do so for most applications; however this will depend on the equipment you are running. Constant excessive demand will slow any of these portable units down a little.

Does this work well with 15 gauge finish nailer? Only specifies framing, 16 & 18 gauge nailers. Thanks

Yes, this will run any pneumatic nailer. It has the capabilities of running up to three 15ga nailers.

Explore

Shop By Category

Added to Cart

Your shopping cart is emptyLets Change that !Continue Shopping

https://m.media-amazon.com/images/I/61lqb4VBkBL._AC_SL1500_.jpg

Metabo HPT

Metabo HPT Air Compressor, THE TANK™, Portable Air Compressor 200 PSI, 6 Gallon Air Compressor, Pancake Air Compressor, Versatile for Use with Framing, Siding, Finish, Brad or Roofing Nailers, EC914S

Item #:27098406

4.7 rating

Write a review

PKR 98653

Availability : Out of stock

Ships from Ubuy, Sold By : UBNA Distribution LLC

Note: Step Down Voltage Transformer required for using electronics products of US store (110-120.). Recommended power converters Buy Now.

Our Top Logistics Partners

At 200 PSI, this compressor offers 25% greater PSI than a basic pancake compressor

Product Details

Brand
Voltage
Recommended Uses For Product
Power Source
Noise Level

Features & Benefits

200 PSI for 25% more pressure than basic pancake compressors
4 CFM @ 90 PSI enables multiple large body nailers
Runs 2 framing, roofing, siding, or 3 finish, or 5 brad nailers
Aluminum construction for corrosion resistance
Contractor grade 6 ball brass coupler
Formerly Hitachi power tools, now Metabo HPT

Product Description

Metabo HPT Air Compressor, THE TANK™, Portable Air Compressor 200 PSI, 6 Gallon Air Compressor, Pancake Air Compressor, Versatile for Use with Framing, Siding, Finish, Brad or Roofing Nailers, EC914S

Overview

Have any Query?Chat with us

Customer Questions & Answers

Question :
Answer : The maximum PSI of this compressor is 200 PSI.
Question :
Answer : Yes, this compressor can simultaneously run 2 framing, roofing, siding, or 3 finish, or 5 brad nailers.
Question :
Answer : This compressor is made of high quality aluminum construction for corrosion resistance.
Question : Anyone use this for media blasting?
Answer : I dont know about the media, but i have used it to blast telemarketers.
Question : Has anyone run this on a 2000W inverter generator?
Answer : Kevin has a point. Yes it will work but the tank will be under load for some time. If you get one of those 2000 watt inverters just make sure it has a fan. Personally I would get a 3000 watt to be on the safe side even though this suckered sucks 15amps quite a lot for just 5.1 scfm
Question : Where do you plug it up
Answer : You plug the cord into a 120V outlet and then on the front of this compressor, there are two 1/4" industrial fittings for your hoses.
Question : Why does my compressor lose air after it fills up
Answer : If you’re using the air (i.e. nail gun etc) your compressor should decrease in air as it’s being used. IF you have “leak” somewhere within tank system you should be able to hear it, as it’s filling; although it likely wouldn’t fill up due to leak ( probably just keep running). Air usage or leak?? Only you know.
Question : Has anybody filled the tires of a ford f350 or other super duty trucks or 80 psi rv tires yet?
Answer : This is a good little compressor for the money. My F350 tires have been low a couple of times and this has filled with no problem. My only reservation is it is loud and has a small capacity tank but it builds pressure quickly up to 200 PSI.
Question : How many decibles?
Answer : It’s not as loud as a push lawn mower - which is around 80 plus decibels. It’s not as quiet as a newer dishwasher - which is around 50 decibels. Guessing - I would say it’s 55-65 decibels. The sound may seem louder the closer you are to it. If your right next to it or bent over in front of it, it’ll likely seem loud, but if your several feet from unit, it’s not that bad. Also sound will obviously seem much elevated if you’re using compressor inside as opposed to unit being used outside. So I assume decibels will and can vary on where and how you are using the compressor.
Question : Will this compressor build to 200psi continuously or is it rated to 200psi and only builds to 175 or 180 as in other brand compressors?
Answer : It will try to hold to 200psi and will do so for most applications; however this will depend on the equipment you are running. Constant excessive demand will slow any of these portable units down a little.
Question : Does this work well with 15 gauge finish nailer? Only specifies framing, 16 & 18 gauge nailers. Thanks
Answer : Yes, this will run any pneumatic nailer. It has the capabilities of running up to three 15ga nailers.

Customer Ratings

4.7 out of 5

197 customers ratings

5 star
79%
4 star
11%
3 star
7%
2 star
2%
1 star
1%

Review this product

Share your thoughts with other customers

Metabo HPT Air Compressor, THE TANK™, Portable Air Compressor 200 PSI, 6 Gallon Air Compressor, Pancake Air Compressor, Versatile for Use with Framing, Siding, Finish, Brad or Roofing Nailers, EC914S

This portable air compressor is heavy duty and popular within the construction trade. It can fill car tires quickly and has a high capacity tank that can hold up to 200 PSI with a maximum regulator of 150 PSI. It is louder than some other portable options but is a durable product built to last.

Pros

Heavy duty and well-built
Can fill car tires quickly
High capacity tank of 200 PSI

Cons

Louder than some other portable options
The regulator is set for a maximum of 150 PSI
May not be strong enough for sprayers

Important Information

Limitations : For products shipped internationally, please note that any manufacturer warranty may not be valid; manufacturer service options may not be available; product manuals, instructions, and safety warnings may not be in destination country languages; the products (and accompanying materials) may not be designed in accordance with destination country standards, specifications, and labeling requirements; and the products may not conform to destination country voltage and other electrical standards (requiring use of an adapter or converter if appropriate). The recipient is responsible for assuring that the product can be lawfully imported to the destination country. When ordering from Ubuy or its affiliates, the recipient is the importer of record and must comply with all laws and regulations of the destination country.
Not all the products listed on Ubuy are for sale, as Ubuy is a global search engine. Products are subject to export/trade regulations.

View Cart & Checkout